E
N
G
L
I
S
H
4
Basic Call Features
Placing a Call
Using the handset:
1. Pick up the handset.
2. Enter the number, and then press the
Send
soft key.
Using the speakerphone:
1. With the handset on-hook, press .
2. Enter the number, and then press the
Send
soft key.
Using the headset:
1. With the headset connected, press
to activate the headset mode.
2. Enter the number, and then press the
Send
soft key.
Note:
During a call, you can alternate between the headset, hands-free speakerphone and handset modes
by pressing the
Headset
key,
Speakerphone
key or by picking up the handset. Headset mode requires
a connected headset.
Answering a Call
Using the handset:
Pick up the handset.
Using the speakerphone:
Press
.
Using the headset:
Press
.
Note:
You can ignore an incoming call by pressing the
Reject
soft key.
Ending a Call
Using the handset:
Hang up the handset or press the
Cancel
soft key.
Using the speakerphone:
Press
or the
Cancel
soft key.
Using the headset:
Press the
Cancel
soft key.
Redial
Press
to enter the placed call list, press or to select the desired entry, and then
press or the
Send
soft key.
Press
twice when the phone is idle to dial out the last dialed number.
Call Mute and Un-mute
Press to mute the microphone during a call.
Press again to un-mute the call.
Call Hold and Resume
To place a call on hold:
Press the
Hold
soft key during an active call.
To resume the call, do one of the following:
If there is only one call on hold, press the
Resume
soft key.