Basic Call Features
Placing a Call
Using the handset:
1. Pick up the handset.
2. Enter the number, and then press the Send soft key.
Using the speakerphone:
1. With the handset on-hook, press .
2. Enter the number, and then press the Send soft key.
Call Mute and Un-mute
Press to mute the microphone during a call.
Press again to un-mute the call.
Redial
Press to enter the Placed calls list, press or to select the desired entry, and then press or the Call
soft key.
Press twice when the phone is idle to dial out the last dialed number.
4
Call Hold and Resume
To place a call on hold:
1. Press or press the Hold soft key during an active call. The first line key LED slowly flashes green.
To resume the call, do one of the following:
If there is only one call on hold, press or press the Resume soft key.
Ending a Call
If you are using the handset, hang up the handset or press the EndCall soft key.
If you are using the speakerphone, press or press the EndCall soft key.
If you are using the headset, press the EndCall soft key.
Answering a Call
If you are using the handset, pick up the handset.
If you are using the speakerphone, press .
If you are using the headset, press .
Note: You can reject an incoming call by pressing
More->Reject
.
Note: During a call, you can alternate between the headset, hands-free speakerphone and handset modes by pressing
the HEADSET key, the Speakerphone key or by picking up the handset. Headset mode requires a connected
headset.
2. Enter the number, and then press the Send soft key.
Using the headset:
1. With the headset connected, press to activate the headset mode.
To Next Page
Loading...
