Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
357
Parameter
dialplan.block_out.number.X
[1]
<y0000000000xx>.cfg
Description
It configures the block out numbers.
Example:
dialplan.block_out.number.1 = 4321
When you dial the number “4321” on your phone, the dialing will fail and the phone screen will
prompt "Forbidden Number".
Note: It works only if “dialplan.digitmap.enable” and “account.X.dialplan.digitmap.enable” are set to 0
(Disabled).
Permitted
Values
String within 32 characters
Default
Blank
Web UI
Settings > Dial Plan > Block Out > BlockOut NumberX
[1]
Parameter
dialplan.block_out.line_id.X
[1]
<y0000000000xx>.cfg
Description
It configures the desired line to apply the block out rule. The digit 0 stands for all lines. If it is left blank,
the block out rule will apply to all lines on the IP phone.
Note: Multiple line IDs are separated by commas. It works only if “dialplan.digitmap.enable” and
“account.X.dialplan.digitmap.enable” are set to 0 (Disabled).
Permitted
Values
0 to 16 (for T57W/T54W/T48U/T48S/T48G/T46U/T46S/T46G/T29G)
0 to 12 (for T53W/T53/T43U/T42U/T42S/T42G)
0 to 6 (for T41P/T41S/T27G)
0 to 3 (for T40P/T40G/T23P/T23G)
0 to 2 (for T21(P) E2)
0, 1 (for CP920)
Default
Blank
Supported
Devices
All phones except T19(P) E2
Web UI
Settings > Dial Plan > Block Out > Account
[1]
X is from 1 to 10.
Example: Adding Replace Rules Using a Replace Rule File
The following example shows the configuration for adding replace rules.
Customize the replace rule template file and place this file to the provisioning server “http://192.168.10.25”.
Example
dialplan_replace_rule.url = http://192.168.10.25/DialPlan.xml
After provisioning, the rules defined in this file are added to the IP phone, and you can use the replace rules on the
phone.
To Next Page
Loading...
Need help?
General
