Yealink VC110 - Endpoint Component Instructions


InitialSetupoftheYealinkDevices(VC110&VC120)
Yourdevicewillwalkyouthroughaguidedsetupusingyourremote.



ConfigureyournetworkinformationfortheYealinkdevice(seeimagebelow)
Usingyourremote,dothefollowingsteps:
1. Menu->Advanced(DefaultAdminPassword:0000)->LANConfiguration
2. Turnoff[DHCP].
3. EnterthePrivateIPaddress,subnetmask,gateway,DNSinformation(providedby
yournetworkadmin)inthecorrespondingfields.
4. PressSavetosavetheconfiguration,thenifthescreenprompts{Rebootnow}.Press
[OK]toreboottheendpoint.

ContactUs
support@easymeeting.net
helpdesk.easymeeting.net
