Network Deployment
To ensure that the VC120 works correctly, please configure it according to the conference role
that it plays. If it is in the head office, please make sure that it can be reached from the public
network. If it is in a branch office, please use an intelligent firewall to deploy it, or just follow the
same steps as for the head office
Head Office
At least one static public IP address is required in the head office to allow branch offices to
connect. The recommended endpoint configurations are as follows :
.
To deploy the VC120 on a public network, you need to assign a static public IP address to the
VC120.
.
To deploy the VC120 in an Intranet, you must assign a static private IP address behind the
firewall to the VC120. In the meantime, do port mapping on the firewall for VC120.
Configure a Static IP
Firstly, configure a static IP for the VC120
For example: you can use the remote control to configure the IP 10.3.20.12 to your VC120.
.
Menu->Advanced (Admin Password:0000)->LAN Configuration
.
Turn off the 【DHCP】
.
Enter the IP address, subnet mask, gateway and DNS information in corresponding fields.
7
To Next Page
Loading...
Need help?
General
