Yealink VCM36-W User Manual

2
Powering on/off
1. Connect the USB-C port on the VCM36-W to the USB port on the PC
using the USB-C cable.
2. Connect the Video Out port on the UVC camera/AVHub to the same PC
using the USB-B cable.
3. Run the Yealink RoomConnect software on the PC.
The Mute LED indicator fast flashes yellow duiring pairing. After paired
successfully, the VCM36-W card appears on the Yealink RoomConnect
software.
4. Disconnect the cable, then you can use the VCM36-W.
Pairing the VCM36-W
1. Connect the USB-C port on the VCM36-W to the USB port on the video
conference system/UVC camera/AVHub using the USB-C cable.
• The Mute LED indicator fast flashes yellow duiring pairing. The display
device will show: Wireless microphone is paired successfully.
2. Disconnect the cable, then you can use the VCM36-W.
E
N
G
L
I
S
H
1. Long tap the mute button for 5 seconds to power on the VCM36-W.
The battery LED indicator flashes green and then off.
2. Long tap the mute button for 15 seconds to power off the VCM36-W.
The battery LED indicator flashes red and then off.
• Pairing directly
• Pairing by Yealink RoomConnect software
Note: Currently, only wired pairing is available.

Yealink VCM36-W Specifications

General

Brand	Yealink
Model	VCM36-W
Category	Conference System
Language	English