Yealink W52P - Regulatory Compliance Information; Part 15 FCC Rules; Industry Canada (IC) Compliance; Class B Digital Device Compliance

! ! Press again to un-mute the call.
Call Hold
! ! Press the Options soft key during a call, and then
select Hold.
Call Transfer
! ! While on a call, press R. Then dial the number you
wish to transfer call to.
Call Waiting
1. Press to enter the main menu.
2. Select ->Call Waiting.
3. Press or to select the desired value from the
Status field.
4. Press or to select the desired value from the
Tone field.
5. Press the Save soft key to accept the change or
the Back soft key to cancel.
Turning Speakerphone On/Off
! ! While answering a call, press to turn
speakerphone on.
Turning Microphone Mute On/Off
! ! While on a call, press to turn microphone mute
on.
! ! Press to turn microphone mute off.
Turning Call Record On/Off
! ! While on a call, press *0 to turn call record on.
! ! Press *0 again to turn call record off.
Forwarding Calls
Note: 8x8 recommends using online call forwarding
instead of phone-based call forwarding so your
call forwarding instructions are stored online
instead of on your phone. If you set your call
forwarding rules on your phone, they will not be
in effect if your phone is disconnected from an
Internet connection.
To enable online call forwarding (Virtual
Office):
1. ! Log on to your Virtual Office Online dashboard at
http://virtualoffice.8x8.com
2. ! Select Settings then Call Forwarding.
3. ! Update your Call Forwarding Rules and press Save.
You can return to Virtual Office Online at any time to
update your Call Forwarding Rules.
Changing Settings
Adjusting Speaker/Headset Volume
1. ! Press or during a call to adjust the volume of
the currently used audio device.
Adjusting Ringer Volume
1. ! Press or when the handset is idle to adjust the
ringer volume.
Changing Ringing Tone
1. ! Press the OK key to enter the main menu, and then
select Settings->Audio->Ring Tones ->Melodies.
2. ! Press or to highlight the Intercom Call
option or the desired line.
3. ! Press or to select the desired ring tone.
4. ! Press the Save soft key to accept the change.
Adding Contact to Local Directory
1. ! Press the OK key to enter the main menu, and then
select Directory.
2. ! Press the Options soft key, and then select New