Yealink W52P - Product Information and Warnings; DECT Product Information; WEEE Warning; Customer Feedback Request

Yealink DECT Phone System Deployment Guide
4
Site survey process is an information gathering process. The information received in the
site survey determines user requirements and the number of cells required to support
traffic. Begin the site survey by interviewing the user representative familiar with the full
expectation of coverage and performance of IP DECT phone solution.
Building details
An initial look at the architecture plans will provide a global overview of the site. System
deployment and installation depend upon the following building details.
 Building identification
 Construction materials, such as walls, floors, ceilings
 Type of use, such as for office, hotel, factory, or store
 Dimensions
 Number of floors
 Height of floors
 Partitioning of floors
The following table gives some general guidelines on the degree to which certain
materials will obstruct the radio signal.
Materials
Degree of Attenuation
Examples
Air
None
Open space
Wood
Low
Door, floor, partition
Plastic
Low
Partition
Glass
Low
Un-tinted windows, partition
Tinted glass
Medium
Tinted windows, partition
Living creatures
Medium
Crowds, plants
Bricks
Medium
Walls
Plaster
Medium
Partitions
Ceramic
High
Tiles
Concrete
High
Load-bearing walls, floors,
pillars
Metal
Very High
Reinforced concrete, metal
cabinet
Signal penetration capability between the base station and handset is strong, while the