Yealink DECT Phone System Deployment Guide
7
mounting the permanent base station. The final position for the first base
station is the intersection point (position 3) of the two radio coverage cells.
Locating the area center for the second base station
1. Place the deployment base station at position 3.
2. Repeat the measurement process to determine the limit of the radio coverage.
3. Place the deployment base stations at position P4 and P5.
4. Measure the radio coverage and determine the limit of the radio coverage of
these two points.
The final position is again the intersection point of the radio coverage cells
indicated by the broken lines, shown by position 6 in the following figure.
5. Follow the above steps to locate area centers for other base stations. Once
identified, place the deployment base station at intersection points where
each of the coverage cells crossed during deployment. Verify the coverage
cells that reache all areas expected.
Note
Make sure the new critical points are placed well within the deployed radio coverage
areas.
For regular mobility users, they can search for the best base station (signal strength is
the strongest) from the four registered base stations before placing a call. For more
information, refer to
Yealink W52P User Guide
.
To Next Page
Loading...
