Yealink W56P - Page 6

6
To restart the base station via the handset:
1. Press OK to enter the main menu.
2. Select Settings, System Settings and then Base Restart.
3. Enter the system PIN (default: 0000).
4. Press Done.
The registration LED and network status LED will turn o simultaneously. After a
period of time, the LED indicators will illuminate solid green again, indicating the
base station has restarted successfully.
To reset the base station via the handset:
1. Press OK to enter the main menu.
2. Select Settings, System Settings and then Base Reset.
3. Enter the system PIN (default: 0000).
4. Select Done.
All individual settings for the base station will reset to factory defaults. This may
take a few minutes. Do not power o until the base station starts up successfully.