Yealink W56P - Page 12

12
YEALINK NETWORK TECHNOLOGY CO.,LTD.
www.yealink.com
environment, you also need
to make sure the value of
the parameter
"network.ipv6_static_dns_e
nable" is set to 1 (On).
IPv6
network.ipv6
_secondary_
dns =
IPv6 address
Blank
Add
It configures the secondary
IPv6 DNS server.
Example:
network.ipv6_secondary_dn
s =
2026:1234:1:1:c3c7:c11c:54
47:23a6
Note: It works only if the
value of the parameter
“network.ip_address_mode
” is set to 1 (IPv6) or 2 (IPv4
& IPv6). In DHCP
environment, you also need
to make sure the value of
the parameter
“network.ipv6_static_dns_e
nable” is set to 1 (On).
mac.cfg
IPv6
network.ipv6
_internet_po
rt.type =
0 or 1
0
Add
It configures the Internet
port (WAN) type for IPv6.
0-DHCP
1-Static IP Address
Note: It works only if the
value of the parameter
“network.ip_address_mode
” is set to 1 (IPv6) or 2 (IPv4
& IPv6).
mac.cfg
IPv6
network.ipv6
_internet_po
rt.ip =
IPv6 address
Blank
Add
It configures the IPv6
address.
Example:
network.ipv6_internet_port.
ip =
2026:1234:1:1:215:65ff:fe1f
:caa
Note: It works only if the
value of the parameter
“network.ip_address_mode
mac.cfg