Yealink W56P - Date and Time

51
YEALINK NETWORK TECHNOLOGY CO.,LTD.
www.yealink.com
64:70:02:9E:D6:92
Note: It has a higher priority
than the value defined by
the parameter
"network.dhcp.server_mac2
".
Network_
Advanced
network.dhc
p.server_mac
2
MAC Address
Blank
Add
It configures the MAC
address 2 that the IP DECT
phones use to authenticate
the DHCP server. If the
authentication is successful,
the DECT phone will use the
IP address offered by this
server.
Example:
network.dhcp.server_mac2=
64:70:02:9E:D6:92
Note: If both the MAC
address1 and MAC address
2 fail to authenticate, the
phone use the IP address
offered by other DHCP
servers in the network.
common.
cfg
IPv4
network.st
atic_dns_
enable
network.stati
c_dns_enable
0 or 1
0
Change
It triggers the static DNS
feature to on or off.
0-Off
1-On
If it is set to 0 (Off), the IP
DECT phone will use the
DNS obtained from DHCP.
If it is set to 1 (On), the IP
DECT phone will use
manually configured static
DNS.
Note: It works only if the
value of the parameter
“network.internet_port.type
” is set to 0 (DHCP).
common.
cfg
VLAN
network.vlan.
vlan_change.
enable
0 or 1
0
Add
It enables or disables the IP
DECT phone to obtain VLAN
ID using lower preference of
common.
cfg