4
Getting Started
Handset Registration
You can register up to 10 handsets to one W70B base station. Each handset
can be registered to 4 different base stations.
When the handset LCD screen prompts “Unregistered!”, long press on the
base station till the registration LED indicator ashes.
There are two methods to register a new handset:
Easy Registration:
1. Press the Reg soft key on the handset to register quickly.
Normal Registration:
1. Press the OK soft key on the handset, and then select Register Handset.
2. Select the desired base station and then press the OK soft key. The handset
begins searching the base station.
3. Press the OK soft key after searching a base station successfully.
4. Enter the base station PIN (default: 0000), and then press the Done soft key
to complete the registration.
To register to multiple base stations, press OK to enter the main menu, and
select Settings->Registration->Register Handset, then repeat steps 2-4.
Note:
• Use Yealink-supplied power adapter (5V/0.6A). A third-party power adapter may damage the handset.
• Check the charging status on the top-right corner of the LCD screen.
Note:
• If the handset is registered to the base station successfully, the handset LCD screen prompts
“Handset Subscribed” and “Base NO.”( the last 4 characters indicate the base station’s MAC
address).
• If the handset LCD screen prompts “Searching for Base”, check that your base station is
powered on.
To Next Page
Loading...
Need help?
General
