| WH62/WH63 Headsets | 84
3. Click Start Register Handset to set the DM to the registration mode.
4. Reboot the headset, undock the headset from the base and hold the Call Control button for 3 seconds
to power off and hold the Call Control button for 3 seconds again to power on.
5. Hold the Call Control button for 5 seconds to put the headset into registration mode, as indicated by
orange flashes and the voice prompt announcing "pairing mode". After opening the registration mode,
the headset will automatically register to the DM.
Note: If you do not register within 2 minutes, the headset will shut down due to a timeout and
you will need to reboot again.
6. You can check the registration status on the Handset Registration.
7. After you register the headset in the system, you can use it to answer the incoming calls.
Pairing the Headset with a Handset
You can also pair the headset with a handset registered on the DM. The headset will get the same
extension number as the handset.
About this task
Please ensure that you have registered the headset and handset to the DM. For more information about
registering handsets, please refer to Registering the Handset.
Procedure
1. On the web user interface, go to Handset & Account > Handset Registration.
2. Select the handset you want to pair with the headset, go to Edit > Paired Terminal, and select the
corresponding headset from the drop-down menu.
3. Click OK. The headset is now registered with the same extension number as the handset.
Using the Headset to Manage Calls
After you pair the headset with a handset, you can use it to manage calls, for example, push calls, retrieve
calls and redial.
Procedure
1. Push: When receiving an incoming call, both the headset and handset will ring. If you answer the call in
the handset, go to Options > Push on the handset, you can push the call to the headset.
2. Retrieve: If you answer the call in the headset, hold the TRAN key on the headset, you can retrieve the
call to the handset.
3. Redial: Double tap the Call Control button on the headset. You can directly call the last call record.
To Next Page
Loading...
