1. Open tank valves on storage tank. Turn valves
counter clockwise to open.
2. Empty the oil drain bottle.
3. Place charge selector valve in desired position.
The unit can charge either on the high side of
the automobiles A/C system or the low side.
Note: Charging directly on the A/C compressors low
side may damage the compressor. Please follow the
OEM recommended charging procedure. YELLOW
JACKET® is not responsible for any damage that
occurs from not following the recommended service
procedure.
Pre-Operation Check List
6
Initial Setup
To ensure quick, successful integration of the Model
830 series into your shop, please follow these set-up
procedures before the first use of the unit.
Step 1: FILL VACUUM PUMP WITH OIL
1. Remove thumbscrews located under the
vacuum pump shelf.
2. Rotate the front of the vacuum pump out to
expose the oil fill port.
3. Remove the red protective cap from the oil
fill port and discard it.
4. Remove the fill cap located on top of the
vacuum pump.
5. Using a funnel, fill with oil to the oil level line
with the provided YELLOW JACKET®
vacuum pump oil.
6. Replace the oil fill cap.
7. Rotate the vacuum pump back into its
original position and replace the
thumbscrews.
Step 2:
FILL SOURCE TANK WITH REFRIGERANT
(also see page 11)
1. Attach the tank refill adapter (Part No.
19153) to the R134a virgin cylinder.
2. Plug unit into a grounded 110V outlet.
3. Turn on the main power switch.
4. When the display reads “SELECT MODE”
press the TANK REFILL key.
5. Follow the user prompts to complete the
tank refill process.
6. When the display reads “SUPPLY TANK
EMPTY” disconnect blue hose.
7. Remove the tank refill adapter from empty
R134a virgin cylinder and place it in the tool
tray located on top of the unit.
The unit is now ready for operation.
Changing User Options
The user can change the settings of some automatic
options that this unit offers. To change these options
do the following:
AUTO RECOVERY HOLD TIME
The unit comes pre-set from the factory to perform
the Recovery Hold Time. The Recovery Hold Time
automatically performs the hold times that are
recommended in the SAE J 2211 standard to insure
that all of the refrigerant is recovered from the auto-
mobiles A/C system. This process ensures that all
the refrigerant is removed from the A/C system and
also prevents overcharging the A/C system when
you recharge it.
To turn this feature off, perform the following steps:
1. Turn the unit off.
2. Hold the ENTER key down and turn on the main
power switch.
3. When the display reads “PRESS START FOR OP”
release the ENTER key.
4. Press the START key.
5. Press and release the START key until the display
reads “RECOVERY HOLD TIME”.
6. Press the ENTER key.
7. Press the INCREASE key until the display reads
“N”.
8. Press the ENTER key to set change.
9. Turn the unit off to exit the control function.
There are several other user defined options that are
preset from the factory and should not be changed
unless instructed to do so by a factory service tech-
nician or an authorized YELLOW JACKET® service
center.
Here is a list of options and the default settings.
MAX RECOVERY TIME 45 MIN
MAX CHARGE TIME 10 MIN
MAINTENANCE REMINDERS Y
To Next Page
Loading...
