Yo-Yo Desk PRO 2 - Fault Protocol and Handling

19
1. FAULT PROTOCOL
STEP 1:
Fault Phenomenon Handling
After connecting the power, press up or down,
the legs do not respond.
1. Re-initialise the table
2. Check if the connection is correct or not
3. Please contact your supplier
After connecting the power, press and hold
and
together, the legs do not respond.
1. Check if the connection is correct or not
2. Please contact your supplier
The legs are rising slowly.
1. Check if the input power is correct or not
2. Please contact your supplier
The legs don’t move according to your operation. 1. Please contact your supplier
One leg moves while the other does not move.
1. Check if the connection is correct or not
2. Please contact your supplier
Legs only move down and don’t move up.
1. Re-initialise the table
2. Please contact your supplier
Table slides down by itself.
1. Check if the load on the table exceeds
75kg or not.
2. Please contact your supplier
The table goes into initialisation frequently.
1. Check if the load on the table exceeds
75kg or not.
2. Check the noise of the motor.
3. Please contact your supplier.