Yo-Yo Desk PRO 2 - Operating the Desk; Initialisation Procedure; Move Up and Down

9
1. INITIALISATION PROCEDURE
STEP 1:
Press and hold
and simultaneously for
more than 6 seconds.
The legs will start to move down at half the
speed of normal operation.
STEP 2:
Keep holding down
and .
The legs will start to move down to the lowest
position and rebound 2-5mm, then stop.
STEP 3:
Release
and at the same time. The initialisation is complete.
The initialisation procedure must be completed before the first running of the table or after
any parts have been replaced.
2. MOVE UP AND DOWN
STEP 1:
Press and hold
The legs will move up.
STEP 2:
Release
The legs will stop moving.
STEP 3:
Press and hold
The legs will move down.
STEP 4:
Release
The legs will stop moving.