YOKOGAWA TY710 - Auto Hold Function

94
4.3.17 AUTO HOLD Function
The instrument can automatically retain the measured value
when the testing leads are handled as described below.
1) Press the HOLD key to select Auto hold function.
 (Thedisplayshowsthe“A•H”symbol.)
2) Connect the testing leads to the circuit under test.
3)Whenthereadingstabilized,thebuzzersounds.
4) Remove the testing leads from the circuit under test.
5) The display shows the measured value that is retained.
 Youcanrepeatsteps2)to4)asmanytimesasyoulikeaslongasthedisplayshowsthe“A•
H ” symbol.
Note
• InDC/ACvoltagemeasurement,theAutoholdfunctionisonlyavailableforrangesgreater
than the 5V range.
• ThisfunctionisnotavailableforTemperature,CapacitorandFrequencymeasurement.
• TheAutoholdfunctioncannotbeappliedtounstablesignals.