YOKOGAWA TY710 User Manual

102
4.6 Set-up Function
The following settings can be made using the Set-up function:
• timesetting
• defaultsettingofdBmmeasurementreferenceresistance
• defaultsettingofdetectionmodeduringACmeasurement
• defaultsettingofLOGGINGinterval
• defaultsettingofnumberdisplay/timedisplayduringLOGGINGmode
• soundon/offsetting(beepofbuzzer)
• resettofactorypresetmode
1) Press the SHIFT key shows “Shift” on the display.
2) Press the LIGHT key while holding down the SHIFT key changes the mode to Set-up mode
(from Set-up to time display).
3)PresstheLIGHTkeychangesthesettingitemsaccordingly.
4)Changevaluesbyusingthe▲(RANGE)keyor▼(REL)key.
5)PresstheHOLDkeytosave/nisheachsetting.
“SEt” appears and the display returns to the setting items.
6) Hold down the LIGHT key for more than one second to return from Set-up mode to
measurement mode.
Note
To cancel any setting, hold down the LIGHT key for more than one second, or turn off by
using the function key.
<Time setting>
Set the time to be displayed during LOGGING mode. Be sure to set the time after changing the
batteries.
1)Display“CLOCK”byusingtheLIGHTkey.
 Thersttwodigitsofthetimeblinkonthesub-display.
HOLD
2)Setthepresenthourbyusingthe▲(RANGE)keyor▼(REL)key.
3)PresstheLIGHTkeytomakethelasttwodigitsblink.
4)Setthepresentminutebyusingthe▲(RANGE)keyor▼(REL)key.
5) Press the HOLD key to save the setting.
 “SEt”appearsandthen“CLOCK.”

YOKOGAWA TY710 Specifications

General

Brand	YOKOGAWA
Model	TY710
Category	Multimeter
Language	English