YOKOGAWA TY710 - Min;Max;Avg Function

97
4.3.21MIN/MAX/AVGFunction
The minimum value (MIN), maximum value (MAX) and average value (AVG) during
measurement are shown. (The range is fixed.) The average value is shown by dividing the
integrated record data by the number of recording times.
Pressing this key starts recording and at the same time the display shows “MIN”, “MAX” and
“AVG”toreleaseAUTOPOWEROFF.
<Recording time>
The timer is activated to show the elapsed time from the start and simultaneously the
renewed time for MIN/MAX is also recorded.
The elapsed time is displayed as follows:
0 sec. to 99 min. and 59 sec.: steps of 1 sec.
100 min. or more: steps of 1 min.
 PresstheHOLDkeytostoprecording.(Thedisplayshowsthe“D•H”symbol.)
<Toconrmtherecordingtime>
 Forconrmingtherecordingtime,presstheMIN/MAXkey.
Subsequent pressing of this key repeats to display the present minimum value (MIN),
maximum value (MAX) and average value (AVG).
Press the HOLD key once again to restart recording.
Tocanceltheconrmingmode,holddowntheMAX/MINkeyforonesecond.
(“MAX” “MIN” “AVG” symbol disappears.)
Note
• Noinuenceisexertedontherecordeddataevenifthetestleadsaredisconnectedwhilethe
recording is stopped.
• If overload is recorded, the MIN or MAX display changes to“ OL” display, resultingin
incorrect average data.
• Forwidelyvaryingsignalmeasurement,settheappropriaterangeinwhichtheMAXor
MIN does not change to “ OL ” display.