98
4.4 Memory Function
<To save a Data in internal memory>
The instrument can save a data using with the following two types of modes.
SAVE-mode: Saves a data for one measurement by manual operation.
LOGGING-mode: Automatically saves a data from the start of logging.
Memory capacity
SAVE-mode: 100 data
LOGGING-mode: Logging data of one time Model TY710 1,000 data
Model TY720 10,000 data
Number of saved data
Number of saved data is 4-digit numbers. When LOGGING-mode, “ L ” is attached
to the top of 4-digit numbers. The instrument allocates the smallest number, between
0000to9999,thathasnotyetbeenused.Usethe
(RANGE) key or
(REL /%)
key switches the number of saved data.
To save a Data (SAVE-mode)
1) Press the MEMORY key. (The display shows the “ MEM ”symbol.)
2) Press the SAVE (HOLD) key.
(The display shows the number of saved data.)
3)PresstheSAVE(HOLD)keytosavethedata.
Another press of the SAVE (HOLD) key saves a data for the second time measurement or
later.
4) To cancel the function, hold down the MEMORY key for one second.
(“ MEM ” symbol disappears.)
Note
HOLD data can be saved.
Hold the display and save it according to the above steps.
To Next Page
Loading...
Need help?
General
