YOKOGAWA UT130 Technical Information

<Toc> <Ind>
4-11
TI 05C01E02-01E 1st Edition : Oct. 31, 2001-00
Step 4
Press the or key to set the target
setpoint 1 (SP 1).
The period flashes while the value is being
changed.
In this example, "200.0°C" is set for the target
setpoint 1.
Step 5:
Press the key once to register the
setpoint.
Flashes during change.
The period is ON.
Step 9:
Press the key for 3 seconds or
more to return to the operating display.
Step 7:
Press the or key to set the target
setpoint 2 (SP 2).
The period flashes while the value is being
changed.
In this example, "300.0°C" is set for the target
setpoint 2.
Step 8:
Press the key once to register the
setpoint.
Step 6:
Press the key several times to display the
parameter "SP 2" (target setpoint 2).
The parameter "SP 2" appears only for the
controller with the "/EX" option.
Flashes during change.
The peiod is ON.
From the previous page
Step 3:
Press the key several times to display the
parameter "SP 1"(target setpoint 1).
The parameter "SP 1" appears only for the
controller with the "/EX" option.

YOKOGAWA UT130 Specifications

General

Brand	YOKOGAWA
Model	UT130
Category	Temperature Controller
Language	English