5.3 Walk boost mode
Long Press and hold , the electric bicycle enters the walk boost mode. Your e-bike will run at the constant speed at
the promoted speed and the display shows . Release to stop the power output immediately and restore to the state
before walk boost.
Figure 5-2 Helping to implement the display screen
The walk boost mode can only be used when pushing the electric bicycle, please do not use it while riding.
5.4 Turning on/off lights
Press the to make the controller turn on the lights and the display backlight becomes dim. Press again to make
the controller turn off the lights and the backlight restore brightness.
Figure 5-3 Backlight display interface
5.5 PAS level selection
Press / to switch PAS level of electric bicycle, thus changing the motor output power. (The following
pictures are only for illustration of different speeds in different gears. The specific speed is subject to the actual product)
Figure 5-4 PAS level display interface
To Next Page
Loading...
