Yongnuo YN-622C User Guide

The Other YN-622C User Guide
28/08/2013 Page 17 of 23
CAMERA FEATURES
Ambient-only shot
• Turn transmitter off. 622 settings are remembered when powered up again.
• Or, use type A camera menu Flash Firing – Disable.
High-speed Continuous Shooting
• Trigger keeps up with camera. (Tested at 6.5 fps.)
• A Flash battery pack is recommended for maintaining flash output consistency.
Live View
• Silent Mode must not be enabled, as Canon then prevents flash from firing.
Modelling Light
• Works as designed. All flashes fire, including on-top flash.
FLASH FEATURES
Flash Zoom (Flash Coverage)
Canon provided a flash head zoom to provide lighting just wide enough to cover the lens’s field of
view. Consider the zoom as a light modifier, for efficiency or artistic reasons, or because the
flashes may be off-camera and lens zoom is irrelevant. The 622 provides more flexibility than
Canon’s implementation. This may be affected by Canon’s rules - Wide panel extended: 14mm;
Head in Bounce on Auto: --mm; Head in Bounce on Manual: as set; Auto-adjust for sensor size
enabled.
Zoom Lock
An individual flash under remote control can have its zoom setting locked so that it is not controlled
by the camera’s zoom menu setting.
• Hold down [CH SET] on a 622 Receiver for several seconds until the channel indicator
stays lit. (This is the same as setting mix control on a transmitter.)
• Adjust the flash zoom setting with the flash control panel (automatic or manual).
• Hold down [CH SET] for several seconds to cancel. The channel indicator will go out.
Zoom and Remote Control
• Remote Control – camera zoom settings apply. Auto; Manual 24 to 105mm (or 200mm).
• With automatic setting, focal length of the flash may change with lens focal length.
• With manual setting, focal length of the flash supports manual setting within 24-105MM.
Zoom and Mix Control
• The camera’s zoom menu setting is disabled.
• Set each flash’s zoom setting on-flash – Auto, Manual 24 to 105mm (or 200mm).
LCD display
• Flash zoom, focal length, ISO, shutter speed, FE Lock, HSS indicators change with
settings.
Pilot Indicator
• Individual test fire works.

Yongnuo YN-622C Specifications

Power

battery type	2x AA batteries (1.5v Alkaline or 1.2v NiMH)
standby time	60 hours
max safe trigger voltage on hot-shoe centre pin	6 volts

Connectors

canon hot foot	with locking ring and pin
canon hot shoe	for mounting hot-shoe flash
pc-sync screwlock socket	sync out only

Weight and Dimensions

dimensions	90 x 53 x 25mm (39mm incl. hot-foot)
weight	79gm without batteries