adjustment increment, totally 29-grade fine adjustment at most; adjust whole grade brightness with [Left] and
[Right] button, and make fine adjustment with [Up] and [Down] button, and the adjustment result shall be directly
shown on the LED screen. At shooting time, you only need to set flash brightness, adjust the camera and press the
shutter; the speedlite shall flash according to the sync signal of the camera.
5. Multi Mode
With Multi mode, a rapid series of flashes is fired. The speedlite will flash according to the output levels, flash
times and frequency you set. Use [LEFT], [RIGHT] buttons to adjust output power, flash times and frequency. The
adjustment scope of output level is 1/128-1/64-1/32-1/16-1/8-1/4, the scope of flash times is from 1 to 100, and the
scope of flash frequency is from 1 to 100. Adjustment method: Please press [OK] button to select setting items
(flash) and use the [LEFT] and [RIGHT] buttons to adjust the parameters. After the setting is completed, press
[OK] button to confirm the setting.
NOTE: The charging speed of speedlite is slow under the situation that the electricity quantity of the battery is
insufficient, which may cause the occurrence of the high-frequency flash. Please reduce the flash frequency or
change new battery under this situation.
To Next Page
Loading...
