York HIC4008B21S - Function Selection by Wired Controller

34
P5417054
8.11 Function Selection by Wired Controller
Each function can be selected with the wired controller. Refer to "Installation and Maintenance Manual" for
wired controller, and the "Service Manual" for indoor units for details.
To set other units, press "Back/Help" at (4), (5) so that the screen will return to (3).
(If the number of indoor unit connected with the controller is 1 (one), the screen will return to (1).)
(1) Press and hold "Menu" and "Back/Help" simultaneously for at least 3
seconds during the normal mode (when unit is not operated). The test
run menu is displayed.
(2) Select “Function Selection” from the test run menu and press “OK”.
(3) Select the indoor unit by pressing “
” and press “OK”.
(This screen is NOT displayed when the number of indoor unit
connected with the controller is 1 (one).
In this case, (4) is displayed.)
Press "All" to select all the indoor units connected to the wired
controller.
OK
Test Run Menu
Input/Output
Thermistor Selection
Function Selection
01
/
03
Test Run
Entr RtrnSel.
Back
Function 5
(4) Press “ ” and select the item required to change.
(5) Press “
” and change the setting.
(6) Press “OK” to display the conrmation screen.
(7) Select “Yes” and press “OK”.
The test run menu is displayed after the setting is conrmed.
If “No” is pressed, the screen will return to (4).
(Figure for Function Selection)
(8) Press "Back/Help" on the test run menu to return to the normal mode.
OK
Adj. Entr RtrnSel.
Back
Function Selection:01-03
04
/
17
C6 00
C5 00
C4 00
C3 00
Item Setting
C2 - -
OK
Function Selection
01-01
All
01-02
01-03
01-04
Entr RtrnSel.
Back
Function Selection:01-03
04
/
17
C6 00
C5 01
C4 00
C3 00
Item Setting
C2 - -
OK
Adj. Entr RtrnSel.
Back
OK
Confirm function
selection setting?
Function Selection:01-03
Yes No
Sel. Entr Rtrn
Back