York YCAQ10 - PRINTER OPTION ASSEMBLY AND WIRING; REQUIRED COMPONENTS AND ASSEMBLY; WIRING DIAGRAM FOR PRINTER CONNECTION

YORK INTERNATIONAL 83
FORM 150.40-NM25
Parts:
The following components are required:
1. Weigh-Tronix IMP-24, Model 2600 printer.
2. 2.25" wide desk top calculator paper.
3. 25 ft. Twisted Pair Shielded Cable (minimum 3 con-
ductor), #18 AWG Stranded, 300V min. insulation.
4. (2) 1 KW ,1/4 W resistors.
5. (1) 031-00929-102 adapter cable. Note: This 4" cable
may already be installed into J6 of the Micro Logic
Board. See the illustration below:
FIG. 57 – ASSEMBLY AND WIRING
*Resistors should be wired into the 031-00929-102 cable. Insulate connection points on the resistors as needed.
Assembly & Wiring:
All components should be assembled and wired as follows in Fig. 57.
6. (1 ea.) 25-pin Cannon connector and shell.
Connector: Cannon p/n DB-25P or equivalent
Shell: Cannon p/n DB-C2-J9
7. (1) 6-pin connector and (3) pins
YORK p/n 025-19668
Connector: or
AMP p/n 1-480270-0
YORK p/n 025-19674
or
Pins: AMP p/n 60619-1
or
61117-1
(Use AMP crimp tool 90287-1, 29004-1, or equiva-
lent to crimp wires to pins.)
LD01631
LD01632