51JOHNSON CONTROLS
FORM NO.: 6U6K-B01E-NB-EN
ELECTRICAL DIAGRAM
All electrical wiring should be carried out in accordance with
local regulations. Route properly sized cables to the cable
entries in the bottom of the power panel.
It is the responsibility of the user to install over current
protection devices between the supply conductors and the
power supply terminals on the unit.
To ensure that no eddy currents are set up in the power panel,
the cables forming each 3 phase power supply must enter via
the same cable entry.
SECTION 5 – TECHNICAL DATA
Cooke Industries - Phone: +64 9 579 2185 Email: sales@cookeindustries.co.nz Web: www.cookeindustries.co.nz
To Next Page
Loading...
