Step 5: Install the Seat Handlebar
Required parts:
1. Align Seat Handlebar (#8) with the two holes on the bottom of the Backrest Support (#7).
Use Half Round Head Inner Hexagon Bolts (#36), Wave Washers (#37), and Screws M8
(#25) to secure it, and then tighten with Socket Head Screw Wrench S5 (#33) and
Multifunctional Wrench S13~15 (#34).
1 Seat Handlebar (#8) 2 Half Round Head Inner Hexagon Bolts M8*40 (#36)
2 Wave Washers φ8*φ18*2 (#37) 2 Screws M8 (#25）
1 Socket Head Screw Wrench S5 (#33) 1 Multifunctional Wrench S13~15 (#34)
To Next Page
Loading...
Need help?
General
