-7-
2.4 Connecting to Power
Use only the supplied car charger to power the dash cam and charge the built-
in battery.
1. Plug one end of the USB charging
cable into the USB Connector on
the car mount (11).
2. Plug the USB cable (13) on the car
mount into the car dash cam's
USB connector (1).
3. Plug the other end into the car
charger, and insert that into
your vehicles lighter socket.
WARNING:
If the environment reaches 115-degrees Fahrenheit or above, the car charger
may stop charging the dash cam battery. This is characteristic of a Lithium
Polymer battery and is not a malfunction.
2.5 Powering the Dash Cam
Automatic Power
• Once the vehicle's engine is switched on, the dash cam will automatically
power on.
• When the vehicle's engine is switched off, the dash cam will automatically
save the recording and power off within 60 seconds.
Manual Power
• To manually turn the power on, press and hold
the Power Button (3) for up to 3 seconds.
• To manually turn the power off, press and hold
the Power Button (3) for 3 seconds.
To Next Page
Loading...
Need help?
General
