PG 12
Simple Screen
This display mode limits the amount of information on screen and limits the functions to just the +/-
arrows and the MENU button.
Hold down the PROGRAM button for 12 seconds to access the limited display screen.
Hold down the PROGRAM button for 12 seconds to leave the limited display screen.
RESET button The RESET button re-boots the CT100 processor. It does not effect the user
programs that have been stored in permanent memory.
Compressor Protection The CT100 has a minimum cycle time of 4 minutes to protect your
compressor in cool and in heat pump (if you have one). The Home screen will show a small clock and
A/C during this time and the compressor will not come on until the 4 minute delay is over.
To Next Page
Loading...
