Z-Wave CT100 - Connectivity; Z-Wave Network Connection; Z-Wave Network Removal

PG 12
PG 13
Communicating Thermostat
The CT100 has a built in Z-Wave radio. This allows your thermostat to communicate with other
systems.
To connect to a network -
To remove from a network -
1] Press Add Devices on your Z-wave controller. The controller will go into Discover Devices
mode.
2] Press MATE on your CT100. [This is located in the MENU screen]
3] The controller will discover the CT100 and add it to the device list.
1] Press Remove Devices on your Z-wave controller. The controller will go into Discover
Devices mode.
2] Press MATE on your CT100. [This is located in the MENU screen]
3] The controller will disconnect from the CT100 and remove it to the device list.