EN.
44
NOTE1: After the value of this parameter is changed, first exclude module (without setting
parameters to their default values), wait at least 30s and then reinclude the module!
Parameter no. 72 – Slats tilting full turn time
Set the time, required by the slats, to make a full turn (180 degrees).
Values (data type is 2 byte dec):
• default value 150 = 1.5 seconds
• 0 - tilting time disabled
• 1 - 32767 = 0,01seconds – 327.67 seconds
NOTE: If the set time is too long and a full turn was already performed, the device will start to
move up or down for the remaining time.
To Next Page
Loading...