Why Zanussi Dishwasher won't start?
If your Zanussi Dishwasher programme isn't starting, ensure the appliance door is fully closed. If a delay start is active, either cancel it or wait for the countdown to finish. Also, the appliance may be recharging the resin inside the water softener, which takes about 5 minutes.
What to do if my Zanussi ZDLI1510 won't drain water?
If your Zanussi Dishwasher isn't draining water, check that the sink spigot and the interior filter system are not clogged. Also, make sure the drain hose isn't kinked or bent.
Why my Zanussi ZDLI1510 Dishwasher is not filling with water?
If your Zanussi Dishwasher isn't filling with water, make sure the water tap is open and that the water supply pressure isn't too low. Also, check that the water tap and the filter in the inlet hose are not clogged, and ensure the inlet hose has no kinks or bends.
What to do if my Zanussi Dishwasher has a small leak from the door?
If there's a small leak from the door of your Zanussi Dishwasher, make sure the appliance is level by adjusting the feet. Also, check if the door is centered on the tub by adjusting the rear foot.
What to do if malfunction of the water level detection sensor in Zanussi ZDLI1510?
If there's a malfunction of the water level detection sensor in your Zanussi Dishwasher, ensure that the filters are clean. You can also try switching the appliance off and on.
What to do if malfunction of the wash pump or the drain pump in Zanussi ZDLI1510?
If there is a malfunction of the wash pump or the drain pump in your Zanussi Dishwasher, try switching the appliance off and on.
What to do if my Zanussi Dishwasher won't activate?
If you cannot activate your Zanussi Dishwasher, first check if the mains plug is correctly connected to the mains socket. Also, verify that there is no damaged fuse in the fuse box.
What to do if the anti-flood device is on in my Zanussi ZDLI1510?
If the anti-flood device is activated on your Zanussi Dishwasher, close the water tap. Ensure that the appliance is installed correctly and that the baskets are loaded as instructed in the user manual.
Why is my Zanussi ZDLI1510 Dishwasher tripping the circuit-breaker?
If your Zanussi Dishwasher trips the circuit-breaker, it may be because the amperage is insufficient for all appliances in use simultaneously. Check the socket amperage and the meter capacity, or turn off another appliance. If this doesn't solve the issue, there may be an internal electrical fault.
What to do if my Zanussi ZDLI1510 door is difficult to close?
If the Zanussi Dishwasher door is hard to close, check if the appliance is level by adjusting the feet. Ensure that no tableware parts are sticking out from the baskets.
General| Energy Efficiency Class | F |
|---|---|
| Number of Place Settings | 9 place settings |
| Noise Level | 49 dB |
| Wash Programs | Eco, Intensive, Normal, Quick |
| Height | 818 mm |
| Width | 446 mm |
| Depth | 550 mm |
| Control panel colour | Black |
| Drying system | Residual heat |
| Connected load | 1950 W |
| Current | 10 A |
| Drying Class | A |
| Programs | Eco, Intensive, Normal, Quick |
| Delay Start | Yes |
| Half Load | Yes |
| Quick Wash | Yes |
To Next Page
