Page 15
E4 INPUT 3 This is a digital input free for customer request. The meaning
depends on the software installed (made by Zapi) and the model
selected with the input E9 and E10.
E5 -BATT Negative free for the customer.
E6 INPUT 4 This is a digital input free for customer request. The meaning
depends on the software installed (made by Zapi) and the model
selected with the input E9 and E10.
E7 CM Positive for the "Input 5"; is a key switch signal interrupted by a diode
for safety reason.
E8 CM Positive for the "Input 6"; is a key switch signal interrupted by a diode
for safety reason.
E9 SELECT 1 This is a digital input for model configuration.
E10 SELECT 2 This is a digital input for model configuration.
E11 CM Positive for the "Input 1"; is a key switch signal interrupted by a diode
for safety reason.
E12 -BATT Negative free for the customer.
E13 INPUT 2 This is a digital input free for customer request. The meaning
depends on the software installed (made by Zapi) and the model
selected with the input E9 and E10.
E14 CM Positive for the "Input 3"; is a key switch signal interrupted by a diode
for safety reason.
E15 -BATT Negative free for the customer.
E16 CM Positive for the "Input 4"; is a key switch signal interrupted by a diode
for safety reason.
E17 INPUT 5 This is a digital input free for customer request. The meaning
depends on the software installed (made by Zapi) and the model
selected with the input E9 and E10.
E18 INPUT 6 This is a digital input free for customer request. The meaning
depends on the software installed (made by Zapi) and the model
selected with the input E9 and E10.
E19 -BATT Negative of the "Select 1" input.
E20 -BATT Negative of the "Select 2" input.
Note:
For the inputs is acceptable a PNP sensor with a 24V output. The maximum load for
single inputs is less than 5mA.
To Next Page
Loading...
