Zapi SEM1 - Periodic Maintenance to be Regularly Repeated

Page 36 SEM1
8 PERIODIC MAINTENANCE TO BE REGULARLY REPEATED
Check the wear of electric contacts: they should be replaced when matchboard is too
strong and worn out. Electric Contacts should be checked every 3 months.
Check pedal microswitch: verify with a tester that there is no electrical resistance be-
tween the contacts by measuring the voltage drop between its terminals. Also the
release should have a firm sound. The pedal microswitch should be checked every
3 months.
Check motor battery power links: they should be in excellent condition as well as the
cable insulation. Wires should be checked every 3 months.
Check the mechanical movement of all contactors. They should be free to move with-
out problem. Mechanical movements of the contactors should be checked every
3 months.
Checks should be done only by suitably trained personnel. All spare parts should be
original. Installation of the electronic controller should be done according to the dia-
grams included in this manual and any variation should be done accordingly with the
supplier. The supplier is not responsible for any problem that rises from using wiring
solutions different from the ones suggested in this manual.
Any problem which is visible or apparent to an ordinary technician who periodically
checks the equipment, that may create damage or defect to the device, should be
transmitted to ZAPI’s technicians or to the technical commercial net.
They will take the responsibility for possible decisions regarding the operational safety
of the electric vehicle.
NEVER USE A VEHICLE WITH A
FAULTY ELECTRONIC CONTROLLER