Cutter
Specifications
The cutter option is a field install able option,
only. The printer covers must be opened to gain
access to the main PCB to install the cutter. This
installation should be performed by qualified
service personnel.
Once installed the cutter is removable to allow
printing in non cutter configurations.
Clearing the
Cutter
The only tool required to clear a jam is a pair of
small tweezers. Never use your fingers or sharp
objects to clear jams.
If you cannot remove the jammed media, call
for service.
Using the Media Cutter
C-2 980412-001 Rev.A
Warranty 90 Days
Mean Time To
Failure (MTBF)
5000,000 cut cycles
Cutting Method Rotating, double edged blade
Media
Media Type Paper, Thermal Paper, Paper Tags, Paper Label Liners
Max. Density 200 grams/meter
2
(approximately 0.010 inches (.254 mm) thick)
Min. Width 1.0 inches (25.4 mm)
Max. Width 4.13 inches (105 mm)
To Next Page
Loading...
