Mounting the
Cutter
Use this procedure to attach and remove a pre
-
viously installed cutter on the printer. The oper
-
ator should reverse the procedure to remove
the cutter.
Step 1 Open the media access door.
Load and set media parameters (via AutoSense
or programming with the Q command) in the
printer.
Step 2 Remove the lower front cover. Lift up on the
lower front cover while holding down the
printer’s base. The cover will un-snap with
steady upward pressure and slide up and out.
Using the Media Cutter
980412-001 Rev.A C-3
Lift (1)
Pull Out (2)
Reverse the process to re-install
the lower front cover
To Next Page
Loading...
