Feed Button/LED and Top Gap Sensor Replacement (Continued) 980358-516A
8. Make sure the sensor's wires are secured
against the top frame using tape.
9. Make sure the LED/Feed Button's ribbon
cable is secured against the top case using
tape.
Assembling the Printer
Perform the assembly steps of the
Ribbon Carriage (980358-415),
Upper Case (980358-414),
Hinge (980358-413),
Main PCBA (980358-409), and
Bottom Case (980358-405)
procedures.
78 980358-001 Rev. B
To Next Page
Loading...