Mobile Printer CPCLProgramming Manual P12-7
Setting the IP Address for Network Printers
1. Create the following document in a text editor such as
Notepad, replacing (192.0.11.195) with your Network
Printer’s address, and (ZebraNet) with the SSID of your
RF Access Point. It may be necessary to obtain this in-
formation from your network administrator:
! UTILITIES
LAN IPADDR 192.0.11.195 SSID ZebraNet MODE LPD
PRINT
Insure each line, including the last, is terminated with
<CRLF>. Save the file in a convenient location.
2. Using a serial communications cable (p/n BL11757-
000), connect the printer to the serial port of a PC loaded
with the Label Vista™ program. Open Label Vista and se-
lect the “Diagnostic Send” utility under the Printer menu.
3. Use the “Browse” button to navigate to the file you cre-
ated in step 1 and click on the “Send” button. The file will
be sent to the printer, and the dialog box will indicate the
download progress.
Once the IP address has been downloaded successfully,
it will stay resident in the printer’s memory until a new IP
address is sent. The IP address can be verified by per-
forming a “2 key reset” on the printer.
The “2 key reset” is initiated by the following key se-
quence:
1. Press the "FEED" key,
2. While still holding down the "FEED" key, press and re-
lease the "ON/OFF" key (Cameo 3N) or the “On” key (En-
core 3N).
3. Keep the "FEED" key depressed until printing starts.
The printer will produce a line of interlocking “x” charac-
ters to insure all elements of the printhead are working,
and then print out a status report.
The resulting printout should include a Wireless Commu-
nications section. You should verify that the following lines
are included, with your IP address and SSID:
To Next Page
Loading...