Mobile Printer CPCLProgramming Manual P14-67
wlan.current_tx_rate
type: getvar
This parameter retrieves the current transmit (tx) rate
(mbps). This rate will vary depending on several factors
such as the Access Point’s settngs and the printer’s dis-
tance from the AP. Possible values are “1”, “2”, “5.5”,
and “11”.
getvar result Current transmit rate
Example Description This command instructs the printer
to respond with the current tx rate.
Syntax !U1 getvar “wlan.current_tx_rate”
Result “11”
wlan.encryption_index
type getvar; setvar
This parameter refers to the WEP (Wired Equivalent Pri-
vacy) encryption key index. This parameter determines
which one of the four encryption keys is to be used by the
client (printer).
getvar result This will return the current encryption key index
that is in use by the printer.
Example Description This command instructs the printer
respond with the encryption key
index value.
Syntax ! U1 getvar “wlan.encryption_index”
Result “1”
setvar choices “1”, “2”, “3”, or “4”
Default “1”
Example Description Instructs the printer to set the en-
cryption key index.
Syntax ! U1 setvar “wlan.encryption_index”
“1”
Result Sets the encryption key index to 1.
continued on next page
To Next Page
Loading...