Zebra CPCL - wlan.leap_password

Mobile Printer CPCLProgramming Manual P14-81
wlan.leap_password
type: getvar; setvar
This parameter refers to the LEAP password. The pass-
word must correspond to a user profile established on the
RADIUS/AAA server in use.
This parameter is not supported on units with a Frequency Hopping Spread
Spectrum (FHSS) radio.
getvar result Returns the LEAP password.
Example Description Instructs the printer to respond with
the LEAP password.
Syntax ! U1 getvar “wlan.leap_password”
Result “password”
setvar choices 4-32 ASCII characters
Default “password”
Example Description Instructs the printer to set the
LEAP password to “password”.
Syntax ! U1 setvar “wlan.leap_password”
“password”
Result The LEAP password will be set to
“password”.