Zebra FX7500 Deployment Guide

Operation Modes
15
Portal
Portal mode configures the radio to report all unique tags that pass by each antenna immediately following
a GPI event. The GPI event signals the beginning of the read period. As soon as the GPI event triggers the
radio, the radio continues to read tags until no new unique tags are read for a configurable stop interval.
Once the radio stops reading tags, it waits for the next GPI event to start the process again.
By default:
• The radio attempts to read tags on all antennas. This can be adjusted using the Antennas object when
setting the mode.
• The radio reports all unique tags once. This can be adjusted using the Filter object when setting the
mode.
• The radio waits for a LOW signal on GPI 1. This can be adjusted using the StartTrigger object when
setting the mode.
• The radio continues to read until no new unique tags have been read for 3 seconds. This can be
adjusted using the StopInterval object when setting the mode.
Conveyer
Conveyer mode configures the radio to read tags and report all unique tags for each antenna.
By default:
• The radio attempts to read tags on all antennas. This can be adjusted using the Antennas object when
setting the mode.
• The radio reports all unique tags once. This can be adjusted using the Filter object when setting the
mode.

Zebra FX7500 Specifications

General

Interface	USB
Product color	White
LED indicators	Activity, Power, Status
Housing material	Aluminium, Metal, Plastic
Battery type	-
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	-20 - 55 °C
Operating relative humidity (H-H)	5 - 95 %
Harmonized System (HS) code	84719000

Weight and Dimensions

Depth	43.2 mm
Width	149.9 mm
Height	195.6 mm
Weight	860 g