Maintenance
Cleaning
62
980610-001 Rev. C GK420t™ User Guide 8/4/10
7.
Align the platen with the gear to the left and lower it into the printer’s bottom frame.
8.
Rotate the platen bearing latch release tabs down on the right and left sides towards the
rear of the printer and snap them into place.
Allow the printer to dry for one minute before closing the dispenser door, media cover or
loading labels.
Other Printer Maintenance
There are no user level maintenance procedures beyond those detailed in this section. See the
Troubleshooting on page 69 for more information on diagnosing printer and print problems.
To Next Page
Loading...
