Test Printing (Configuration Report)
26
P1032729-003 Rev. A GT800™ Thermal Transfer Printer User Guide 9/30/2014
Test Printing (Configuration Report)
Before you connect the printer to your computer, make sure that the printer is in proper
working order.
You can do this by printing a configuration report.
1. Make sure the media is properly loaded and the top cover of the printer is closed. Then,
turn the printer power on (if you have not already done so). If the printer initializes with
the status light blinking green (pause mode), press the Feed button once to set the printer
in Ready (to print) mode. See the Troubleshooting on page 81 if the printer’s status light
does not turn solid green (Ready).
2. Press the Feed button two to three times to allow the printer to calibrate the printer for the
installed media. The printer may feed several labels during this process.
3. When the status light is solid green, press and hold the Feed button until the status light
flashes once.
4. Release the Feed button. A configuration report will print.
If you cannot get this label to print, refer to Getting Started on page 9.
To Next Page
Loading...