Zebra HC100 - Setting, Changing, and Restoring Print Server Settings

61337M ZebraNet™ Internal Wireless Plus Print Server Assembly Kit
Remove the Outer Enclosure and Trim
66
61311L-001 Rev. A HC100 Maintenance Manual 5/8/08
3. See Figure 38. Using a Phillips screwdriver, remove the two mounting screws.
Figure 38 • Remove the Mounting Screws
4. Press the upper cover release buttons located on both sides of the printer and then lift the
outer enclosure slightly off of the base.
1
Outer enclosure
2
Enclosure mounting screws (2)
3
Upper print mechanism cover
4
Upper cover release buttons (2)
5
Base
1
2
5
4
4
3