Zebra HC100 - Page 19

19
Introduction to the HC100
Control Panel
11/15/10 HC100 User Guide 61207L-002 B
Table 1 • Function of the Control Panel Buttons
Button Function/Description
EJECT
This button functions only when the printer is idle or paused. The function depends on
whether you press the button or press and hold it.
• Pressing and releasing
EJECT causes the printer to retract the current wristband and
eject the media cartridge.
• Pressing and holding
EJECT for 6 seconds force ejects the media cartridge without
retracting the protruding wristband. After a forced eject, press the upper cover release
buttons to open the printer’s upper cover and release the wristband. See Media Cartridges
on page 20 for information on removing the wristband from the cartridge. Do NOT pull
the remainder of the wristband out of the cartridge.
Note • If pressing EJECT does not eject the media cartridge, power cycle the printer
and press
EJECT again. Use the forced eject option only as a last resort if these other
attempts fail.
PAUSE/FEED
PAUSE/FEED
has different functions depending on whether the printer is idle or paused and
on whether you press the button or press and hold it.
• Pressing and releasing
PAUSE/FEED has two functions.
•Pause—
PAUSE/FEED functions as a pause button when the printer is actively printing
a wristband. While a wristband is printing, press the button to pause the printer before
the next wristband starts printing. The printer remains paused until you press the button
again.
•Feed—
PAUSE/FEED functions as a feed button when the printer is idle. Press the
button to feed one blank wristband.
• Pressing and holding
PAUSE/FEED places the printer in user configuration mode. The
printer status indicator lights blink orange in 2-second intervals, adding one blink each
interval. Depending on when you release
PAUSE/FEED, different actions take place:
• One orange blink—A printer configuration wristband prints.
• Two orange blinks—A media sensor profile prints.
• Three orange blinks—The printer resets all print server parameters (wired Ethernet and
wireless Ethernet) back to defaults.
• Four orange blinks—The printer resets all printer parameters back to defaults.
• After four orange blinks, the printer exits user configuration mode. The printer status
lights return to solid green. The printer feeds a wristband when you release
PAUSE/FEED.