Advanced User Information
Changing and Restoring Printer Settings
62
61207L-002 B HC100 User Guide 11/15/10
FORMAT PREFIX Set Format Prefix Character
The format prefix is a two-digit hex value used as a parameter place marker in
ZPL/ZPL II format instructions. The printer looks for this hex character to
indicate the start of a ZPL/ZPL II format instruction. See the ZPL II
Programming Guide for more information.
Note • Do not use the same hex value for the control, format, and
delimiter character. The printer must see different characters to work
properly.
Default Value: 5E ^
Range: 00 to FF
Corresponding ZPL Command: ^CC or ~CC
Corresponding SGD Command: None
Located on Web Page: ZPL Control
DELIMITER CHAR Set Delimiter Character
The delimiter character is a two-digit hex value used as a parameter place marker
in ZPL/ZPL II format instructions. See the ZPL II Programming Guide for more
information.
Note • Do not use the same hex value for the control, format, and
delimiter character. The printer must see different characters to work
properly.
Default Value: 2C ,
Range: 00 to FF
Corresponding ZPL Command: ^CD or ~CD
Corresponding SGD Command: None
Located on Web Page: ZPL Control
ZPL MODE Select ZPL Mode
The printer remains in the selected mode until it is changed by this parameter or
by using a ZPL/ZPL II command. The printer accepts wristband formats written
in either ZPL or ZPL II, eliminating the need to rewrite any ZPL formats that
already exist.
Default Value: ZPL II
Range: ZPL II, ZPL
Corresponding ZPL Command: ^SZ
Corresponding SGD Command: None
Located on Web Page: ZPL Control
Table 9 • Printer Parameters (Continued)
Parameter Details
To Next Page
Loading...
