63
Advanced User Information
Changing and Restoring Printer Settings
11/15/10 HC100 User Guide 61207L-002 B
LABEL TOP Adjust Top Position
This parameter adjusts the print position vertically on the wristband. Positive
numbers adjust the top position farther down the wristband (away from the
printhead) by the specified number of dots. Negative numbers adjust the top
position up the wristband (toward the printhead).
Default Value: +000
Range: +000 to +120 dots
Corresponding ZPL Command: ^LT
Corresponding SGD Command: None
Located on Web Page: General Setup
LEFT POSITION Adjust Left Position
This parameter adjusts the print position horizontally on the wristband. Positive
numbers adjust printing to the left by the specified number of dots. Negative
numbers shift printing to the right.
Default Value: 0000
Range: –9999 to +9999 dots
Corresponding ZPL Command: ^LS
Corresponding SGD Command: None
Located on Web Page: Advanced Setup
REPRINT MODE Enable Reprint Mode
When reprint mode is enabled, the printer reprints the last wristband after you
correct an error condition.
Default Value: DISABLED
Selections: ENABLED, DISABLED
Corresponding ZPL Command: ^JZ
Corresponding SGD Command: None
Located on Web Page: None
ZBI Run ZBI 2.0
If your printer was not factory-enabled with ZBI 2.0, you must purchase a
ZBI 2.0 Activation Key to use ZBI 2.0. Contact your authorized Zebra reseller for
more information.
Default Value: STOPPED (DISABLED)
Selections: STARTED (ENABLED), STOPPED (DISABLED)
Corresponding ZPL Command: ^JI or ~JI to start, ~JQ to stop
Corresponding SGD Command: zbi.control.run to start,
zbi.control.terminate to stop
Located on Web Page: None
Table 9 • Printer Parameters (Continued)
Parameter Details
To Next Page
Loading...
