Advanced User Information
Changing and Restoring Printer Settings
64
61207L-002 B HC100 User Guide 11/15/10
FORMAT CONVERT Select Format Convert
Selects the bitmap scaling factor. The first number is the original dots per inch
(dpi) value; the second, the dpi to which you would like to scale.
Default Value: NONE
Selections: NONE, 150 300, 150 600, 200 600, 300 600
Corresponding ZPL Command: ^MU
Corresponding SGD Command: None
Located on Web Page: Advanced Setup
NONRESET CNTR View Non-Resettable Counter
This parameter displays the total length of media that the printer has printed. You
can use ZPL commands to change the unit of measure for this counter.
Corresponding ZPL Command: ~HQ to view, ^MU to change unit of measure
Corresponding SGD Command: odometer.total_print_length
Located on Web Page: None
RESET CNTR1 View User-Controlled Counter 1
This parameter displays the total length of media that the printer has printed since
this parameter was last reset. You can use ZPL commands to change the unit of
measure and reset this counter.
Corresponding ZPL Command: ~HQ to view, ~RO to reset, ^MU to change unit of
measure
Corresponding SGD Command: odometer.media_marker_count1
Located on Web Page: None
RESET CNTR2 View User-Controlled Counter 2
This parameter displays the total length of media that the printer has printed since
this parameter was last reset. You can use ZPL commands to change the unit of
measure and reset this counter.
Corresponding ZPL Command: ~HQ to view, ~RO to reset, ^MU to change unit of
measure
Corresponding SGD Command: odometer.media_marker_count2
Located on Web Page: None
Table 9 • Printer Parameters (Continued)
Parameter Details
To Next Page
Loading...
